Concrete Panels – Dual Reflective Airspace Installation Guide

wall insulation melbourne

Simple step by step guide to installing Foilboard® GREEN rigid insulation

Concrete Panels

Step 1

Install ‘LC Beta Fix Clips’ to wall at 600-900mm centres.

concrete insulation

Step 2

Place the Foilboard® over the dip, teeth from dip will protrude through panel.

insulation contractor

Step 3

Lock appropriate furring channel or similar into place over Foilboard®.

cavity wall insulation

Step 4

Tape all joins to create a thermal break

Flexifast Fastener

Step 5

Fix internal lining to furring channel.

Handling and Storage

Calculations are based on the use of the ‘LG Beta Fix’ bracket and Rondo 129 (16 mm and 28mm furring channels) available through RONDO®) and all good plaster suppliers.

insulation contractor

Instructions are a guideline only and should be interpreted with consideration for the specific building application, Alternative installation methods may be used provided the airspaces adjacent to the Foilboard® are maintained and the material is non load bearing. Please contact Foilboard Australia Pty Ltd for further information. Safe installation practices are encouraged at all times.

It is recommend that if the product is being stored for extended periods it should be kept clean and dry, Any moisture present between sheets should be dried to prevent potential oxidization and must not be stored with either foil surface in contact with any alkaline materials.

In need of further technical advice or assistance?

Foilboard® Technical Department is available to assist

Designing a Building?

Designing a Building?

Doing it yourself?

Doing it yourself?