Factory Roof Insulation (new or old) Installation Guide

cavity wall insulation

Simple step by step guide to installing Foilboard® GREEN rigid insulation

foilboard insulation panel

Step 1

Fix the Foilboard® to the underside of new or existing purlins using recommended fixings. Recommended maximum span of purlins to be no greater than 1 200mm, larger spans may require the installation of battens to the underside the purlins prior to fixing.

Factory Roof Insulation (new or old)

Step 2

Install the Foilboard® to the underside.

Factory Roof Insulation

Step 3

Butt join and tape sheets to using a 50mm pure aluminium tape.

Flexifast Fastener

Step 4

Ideally, a 50-100mm reflective airspace above the Foilboard® should be achieved.

Handling and Storage

Factory Roof Insulation

Instructions are a guideline only and should be interpreted with consideration for the specific building application. Alternative installation methods may be used provided the airspaces adjacent to the Foilboard®. are maintained and the material is non load bearing. All penetrations must be effectively sealed to reduce any risk of damage caused by the possible exposure to extreme radiant heat. Please contact Foilboard Australia Pty Ltd for further information. Safe installation practices are encouraged at all times.

It is recommend that if the product is being stored for extended periods it should be kept clean and dry. Any moisture present between sheets should be dried to prevent potential oxidization and must not be stored with either foil surface in contact with any alkaline materials.

In need of further technical advice or assistance?

Foilboard® Technical Department is available to assist

Designing a Building?

Designing a Building?

Doing it yourself?

Doing it yourself?