Suspended Floor Slab Installation Guide

cavity wall insulation

Simple step by step guide to installing Foilboard® GREEN rigid insulation

Suspended Floor Slab

Step 1

Fix battens or similar (25mm minimum) to underside of concrete slab at 600-1200mm centres.

Step 2

Place sheet of Foilboard® up against battens/channel.

Underfloor Insulation

Step 3

Fix sheet to battens/channel using recommended fixings.

cavity wall insulation

Step 4

Butt join and tape sheets to create a thermal break.

Handling and Storage

Instructions are a guideline only and should be interpreted with consideration for the specific building application. Alternative installation methods may be used provided the airspaces adjacent to the Foilboard® are maintained and the material is non load bearing. All Penetrations must be effectively sealed to reduce any risk of damage caused by possible exposure to extreme radiant heat. Please contact Foilboard Australia Pty Ltd for further information. Safe installation practices are encouraged at all times.

It is recommend that if the product is being stored for extended periods it should be kept clean and dry. Any moisture present between sheets should be dried to prevent potential oxidization and must not be stored with either foil surface in contact with any alkaline materials.

In need of further technical advice or assistance?

Foilboard® Technical Department is available to assist

Designing a Building?

Designing a Building?

Doing it yourself?

Doing it yourself?